[China Glass Net] 1 The thickness of the regenerator wall is 578mm, of which the side wall and the end wall are composed of refractory bricks, bricks and bricks and insulation bricks. The expansion joints can be set in sections when laying. The partition wall is composed entirely of refractory bricks (two bricks and a half), and the expansion joints must be left at both ends of the partition wall. 2 The grate bar is a key part of the regenerator, and it must be ensured that it must be pulled through the wire, and each grate cannot be skewed. The screed bricks are leveled with screed bricks, and the upper surface of the screed bricks should be leveled to facilitate the tiling of the tiling bricks. Float glass furnace kiln grate shovel work time is long, must be fine construction. At present, it is very common to process the lower surface of the leveling brick with appropriate mud. After the completion of the work, according to the requirements of the grate bricks to level the bricks of the high-elastic line, and each brick is numbered, the leveling bricks are removed, cut according to the line marks, and then re-sanded according to the number position, press Elevate the wire and correct the height with an angular grind. 3 After the rear wall of the regenerator is built to the height of the bottom of the small furnace, it is suspended, and the construction of the chest wall and the small furnace is carried out. The construction of the rear side wall can be continued after the small furnace slanting and the rear slab masonry are completed. 4 Grid brick code requires vertical, horizontal, checkered bricks should be packed in positive and negative tolerances after production inspection, and the tolerance range is marked on the package. The same layer of checkered bricks requires the use of lattice bricks of the same tolerance range.
Microfiber Leather,Pu Microfiber Leather,Microfiber Leather Fabric,Microfiber Faux Leather
WENZHOU JOVAN INTERNATIONAL COMMERCIAL , https://www.jovanleather.com